As mentioned earlier, you might want to put on a plastic protector before you begin this phase. Using the micro SD card, we will boot up your Raspberry Pi 3.įirst, be careful not to touch any parts of Raspberry Pi 3. It’s a customized Linux for Raspberry Pi based on the Debian Linux distribution. Now, we are ready to boot Raspberry Pi 3. Once the copy is complete, safely remove the SD card from your computer (or your SD card reader). ![]() Once again, you must copy the folder’s contents (but not the folder itself) to your FAT-formatted micro SD card. Copy the NOOBS files to your micro SD cardĪll you need is to copy the contents of the extracted folder (not the folder itself) to your micro SD card.NOOBS is available for download from here on the Raspberry Pi website. Download NOOBS ( New Out Of Box Software).3.2 Download and copy the NOOBS files to your micro SD card Other formatting tools (if your micro SD card is more than 32GB)Īs my micro SD card is 64GB, I used Disk Utility, one of the standard tools available on macOS, to format it with the FAT format.More details are available here from the Raspberry Pi website. Otherwise, it will use the exFAT format, which does not work with Raspberry Pi (i.e., it will not boot up). You can use it to format your micro SD card to FAT format if it’s 32 GB or less. SDFormatter is a tool available from the SD Association. SDFormatter (if your micro SD card is 32GB or less).Download and copy the NOOBS files to your micro SD cardģ.1 Format your micro SD card (FAT format).Then, all you need is the following two steps to make a bootable OS installation disk. If you do, place your micro SD card into the full-sized adapter and stick it into the SD card reader (built-in or attached to your computer). You need at least 8 GB of storage on your micro SD card. Raspberry Pi 3 uses a micro SD card for storage (OS, libraries, and user programs). 3 Make an OS installer on the micro SD card We need to make an OS installer on a micro SD card to boot up your Raspberry Pi 3. I used a Logitech USB keyboard and mouse.īut don’t hook up any cables yet. 2.5 USB Keyboard and USB MouseĪny keyboard and mouse will do as long as they have a USB interface. Usually, a power adapter has a seal with those details. Note: It should be a 5-volt 1 amp power supply. As long as you can take the power supply from there, it’s ok. If not, I could plug the normal USB side into my Mac Book Pro or an external battery power bank for my mobile phone. I also had a power adapter with a USB interface. I have a box full of unwanted cables at home in which I found Micro USB cables. I have spare HDMI cables at home, so I used one of them. I don’t have an external computer monitor at home, so I used a TV with HDMI slots. ![]() Later, we’ll format the SD card and install software on it. But if your computer does not have one, you’ll need an external SD card reader connected to your computer. My Mac Book Pro from 2012 has a built-in SD card reader. But there is a catch when you format an SD card with more than 32GB (details on this later).Īs mentioned earlier, you’ll need an SD card reader connected or built-in to your computer. The micro SD is where you install OS and all the software. 2.2 Micro SD (with a full-size SD adapter) ![]() The cup on the left is for size comparison (not part of the Raspberry Pi 3 package, in case you are wondering).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |